Why perform dissolution multimedia study in dissolution
Development
- 4 Answers
- 18980 Views
- Cipla, Optimus, I also Faced
- E-Mail Answers
Answer Posted / sandeep singh
If the dissolution is slower
than gastric emptying, a dissolution profile with multiple time points in multimedia is
recommended.
In the case of low solubility/high permeability drugs (case 2), drug dissolution may be the rate
limiting step for drug absorption and an IVIVC may be expected. A dissolution profile in multiple
media is recommended for drug products in this category.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
In BP2013, Loperamid HCl monograph. Assay by titration with 0.1N sodium hydroxide using hydrocloric acid 0.01N and reading the volume added between the 2 points of inflexion. I have a question that if the diluent solvent is ethanol is certainly consumed a amount of volume of titrant, so this volume must be eliminated on the result calculation or not apart from first point which is subtracted above.
From where require to take the RLD sample?
What is a difference between potency and purity?
Why to use propyl paraben in HPLC gradient calibration
What is the difference between purge septum flow and column flow in gas chromatography?
How to determine water content of bis tetrazole amine mono ammonium salt
why cone formation during dissolution?
why are measure gas flow " ml " in Gas chromatography
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
How we choose the mobile phase for method development.?
What is the principle of Thermal conductivity detector and FID?
iam usig ph buffers merk. manually how to prepare ?
analytical method validation require to with respect to release specification or shelf life specification?
Why potassium dichromate is used in calibration of uv?
why digestion require in icpms?
