Interested to Buy Any Domain ? << Click Here >> for more details...
Sir, my yokugava FF TYPE LEVEL transmitter us bad, i don't have spares available, i want to replace it with a Rosemount FF transmitter, please tell me what procedure to be followed and what changes to be done in dcs part.
- 1 Answers
- 3565 Views
- BPCL Bharat Petroleum, OEG, I also Faced
- E-Mail Answers
Answer Posted / rajesh.
If the device calibration range is alike, and all required instrument data are match, we can use. We need to change instrument details like model#, serial#, make etc. in DCS engineering station. Upload, and down load data to communicate it online. And proceed to check as LEVEL both side in field as well as in DCS panel.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why do you want to work here
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
what is loop1 and loop2 in MTS LT?
What is the cascade control
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
Specify for Cables - Flame Retardant and Fire Resistant?
why is not useing in boiler skin thermocople
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is modbus?
How hart protocol can be connected with control valves?
what is a half wave, full wave, and bridge rectifer.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
