Interested to Buy Any Domain ? << Click Here >> for more details...
why scott connection is done why not two phases are directly
picked at the output of 3 phase transformer??
- 1 Answers
- 2736 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudipt jena
Scott connection is done to get two phase supply from 3 phase input power. If we directly pick two phase from three phase supply , then the circuit becomes unbalanced.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
any one can explain the stages of a knee point which is taken during ct magnetising curve.
What is the different types of cable & current capacity of cable
Why earthing is necessary for any equipment?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
AL=0B9H,bl=75H, ADD AL,BL AL=____________? CF________? OF___________?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
why only exciting current is shown not primary current in transformer???
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
