Interested to Buy Any Domain ? << Click Here >> for more details...
what is skin effect and why is it absent in DC systems
- 4 Answers
- 17636 Views
- I also Faced
- E-Mail Answers
Answer Posted / kishore
skin effect is because of rms current flowing through the conductor. ac current flows through the surface of the conductor where as in case of dc conductor it is not surface current.
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
What is purpose of reactor?.What is different between line and bus reactor?
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
in non technical way how can u define POWER FACTOR??
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
operation of diesel generator
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
why you don not show protection and type of isolation in key single line diagram?
why the active power flow of some line is increased when the active power of out is cut ?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
