Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between transmitter and converters?
- 9 Answers
- 34991 Views
- Videocon, I also Faced
- E-Mail Answers
Answer Posted / gautam
Tx. Means transmit the single as 4 to 20 ma which should be in electrical form only but in case of converter is nothing but transducer which converts 1form of energy to an another form whether it can be mechanical to electrical or electrical to mechanical or electrical to electrical.....
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
how to convert cubic metre per hour to newton cubic metre per hour
How to calibrate Field bus transmitter? procedure ?
Calibration of controller (pneumatic)
why we are not using the turbine flow meter in the steam service?
How to calibration a control valve?
why using negative supply for bentley nevada vibration system ?
where cascade loop use ?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what is the procedure of belt scale calibration?
What is the purpose of bypass valve across AS valve.
what is the reset offset and control system in instrumentation
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
