we have one pumping station and 4.6 MW 7 no.s synchronous motors.so there is no required HT capacitor to improve power factor.But we have two no.s of 25 Mva power transformer connect to distribute the power for motors connect with 220 kv line.So i have required the HT capacitor to improve power factor at HT side i mean power transformer bus side.So please suggest how much HT capacitor banks required for same.
Answer Posted / subhra kanta mohapatra
2 nos
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
difference between a diode and thyristor?
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
How to synchronization will be done between two DGs ?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
WHAT IS THE PARTIAL DISCHARGE TEST?
what is the maximim current drawn by 1 phase and three phase welding machine
what is meant by class 1 E in electrical power supply?
is it possible to have dc motors on single chip
What is dielectric loss?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?