Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nilesh parmar
There is one simple method to messure earth by using earth tester
It has 4 terminal say P1 P2 E1 & E2..
Normally E1 & P1 are short together..and make one terminal which connect with the earth pit which to be messure
And now E2 and P2 are connected with earth rod by 10-15,mtrs wire....rod is grounded already in opposite direction meter...
Turn ON meter
Push button press...
And get the earth resistance value...
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Why is ignitor used in sodium vapour lamp
which type of motor is used in automatic swing gate
What is servo motor and what are the applications of servo motor?
how to compute kvar in substation feeder to improve power factor and sending voltage
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
What is difference between slip rings and carbon burushes?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what is the difference between ups & inverter
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
Explain Energy and Power signals?
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
What is a commutator?
