Interested to Buy Any Domain ? << Click Here >> for more details...
what is the working principle of vortex flowmeter
- 9 Answers
- 22561 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / yugesh shah
Working principle is piezo electricity..
When liquid or vapor passing from vortex meter at that time sensor activate and produce mechanical distoration so at the end emf produces.
In the between of the metal body there is a piezo electric crystal, amplifier in upper side and analog meter in other side...
Both side flange in line of vortex meter
Emf produce and given to amplifier
There is 24v dc to operate an amplifier
Output of amplifier connected with i --> p
Produce 0.2 to 1.0kg/cm2
Given to recorder or controller
Output of controller given to control valve
From that changes in output of controller, valve changes its position as per set point
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how to calibrate Necleuonic level transmitter.?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
what is RTV function in in process control?
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what about your moleg in pogrees with company
What is cut off relay? And why use in PLC and DCS?
What is instrumentation control?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
What is the use of single seated valve?
