What different types of problems do occur while doing the loop checking? and please explain in detail or mail me at kadam.aniket143@gmail.com
Answer Posted / govardhan
if u didn't got the continuity,
1. make sure about the perol from field to jb ,jb to field
2. make sure about the core number
3. make sure about the terminals are properly terminated or not?
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the input of digital counter during the the calibration time?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Explain the key components of control loop?
What are advantages and disadvantage of the ac supply load cell?
Explain plc level and its type?
Please tell me details about Sox,Nox,SWAS analyser????
What is the difference between PLC and DDC?
how many type of plug are used in pneumatic control valve,name them.
Why trim span ? How?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
how to calibrate load cell
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.