why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..
- 3 Answers
- 8927 Views
- GIPCL, OEGI, I also Faced
- E-Mail Answers
Answer Posted / vikram thakur
if tapping is after primary super heater than it may cause starvation to secondary super heater, thus secondary super heater will get over heated due to lack of supply of feed water.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
procedure of how to generate power in solar plant.
What is difference between secondary Air & Tertiary Air and Their use.?
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
why airtel use + 24 volts and other operators use -48 volt
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
why do you consider yourself a suitable candidate for this position
What is LB-SR.
Why superheated are started before I'd and rd fan?
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
what is the meaning of SST300 V56A in SIEMENS turbine
what is natural frequency of turbine shaft .
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
what is restricted earth fault explain in details
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
