Interested to Buy Any Domain ? << Click Here >> for more details...
on 22.03.2015 at 17:15hrs Y phase 66kV class Power Trf-2 Current transformer has flashed over and oil came out. The failed CT has been replaced on 24.03.2015 at 13:15hrs and the Trf has been charged in presence of RT Hassan after conducting the pre-commissioning tests. On the same day at 17:00hrs the commissioned CT has again flashed over and immediately the Trf has been isolated from power supply. It is confirmed the secondary is not opened and checked the earth integrity and is found ok. Here what would be the reason for the CT failure?
- 2 Answers
- 3245 Views
- I also Faced
- E-Mail Answers
Answer Posted / dheeraj.yadav
It may be cause due to meter internally circuit open the secondary of ct in meter.due to circuit problem.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
How to megger test 11 kV cable and the acceptance IR value
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
why different series of vfds (like allenbradley)are used in industry ?
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
In a single how much maximum current and watts using
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
how will calculate the safe starting current of 3-phase squirrel cage induction motor?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
What is the working principle of servo motor? And explain it.
What cmos is and its benefits?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
