What should be the earthing resistance of an industrial
substation and also What should be the house hold earthing
resistance?
Answer Posted / pankaj datreliya
How Many 11kv Trasformer Body & Neutral Earthing value?14th Floor LA Earthing Value.and Panel Body earthing value.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
What is the control action?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
How to address the servo drive for motor
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
Why syn. Generators are used for the production of electricity?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
what is the use of permanent magnet generator in exciter
how to calculate transformer turn primary & secondary side 11kv to 420v
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is gross error?