Interested to Buy Any Domain ? << Click Here >> for more details...
why 4-20 mA signal is preferred over a 0-10V signal
- 17 Answers
- 76611 Views
- Sofcon, I also Faced
- E-Mail Answers
Answer Posted / pooja
becoz in 0-10 v there is voltage drop due to increase in resistance ( due to increase in length) that us why signal obtained is not accurate
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Explain the combusion chamber
With N nodes and B branches what will have a network ???
How to measure the dust in chimney(spm)?
how to calculate the total flow in square root
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
full process of gas turbin?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
how works encoder in plc
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
