Interested to Buy Any Domain ? << Click Here >> for more details...
why using 4-20ma not using 0-20or why not using 1-
20ma???????
- 7 Answers
- 9055 Views
- I also Faced
- E-Mail Answers
Answer Posted / kalpit thakkar
Instrument has own Load of 3mA. so we go for 4-20mA. & Also IEC Approved to 4-20 mA.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calibrate and troubleshooting of leveltroll?
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
How to fix back the valve actuator stem
Give 2 application of quartz crystal used for process parameter measurement.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
how to turbine speed measurement?
How d.p. Transmitter can be applied to open tank?
How to convert milliampares into flow??
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is actual drum level and compensated drum level?
What is three element in drum level?
Tr. Wiring for calibration.
What is the reason PT speed not incresed in gas turbine?
