Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sbaskar
psv is pressure safety valve it pops up at the set pressure and resets at the set pressure.the operation is sudden
prv is pressure relief valve it opens when the pressure gets increased.the operation is gradual.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is a good device to use for obtaining viscosity data for a non-newtonian fluid?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?
whats the allowed tolerance of pipe to pipe butt joint mismatching
How i can calculate heat transfer in reactor at unsteady state and what data should i have? I want equation and process to calculate it? As there is steam or brine in jacket
What is the definition of 'good' cooling tower water?
Is there a difference in mtd (mean temperature difference) between 'e' and 'j' (divided flow) type shell and tube heat exchangers?
Explain how can you determine the proper pipe thickness for a slurry line?
Define viscosity?
Where the Induced draft, forced draft & balanced draft furnace are to be used? Selection of furnaces are based on which criteria?
What is fuel requirement of 20kg/hr of incineration having material calorific value 6500 kcal/kg and diesel calorific value 10707 Kcal/Kg (PCC=850 degC and SCC 1050 Deg c)
What are some common precipitating agents used to remove metals from aqueous waste streams?
What are some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?
How can you estimate a gas flow based on two pressure measurements?
I HAVE DOMAIN KNOWLEDGE IN PROCESS MANUFACTURINGAND I GOT AN APPARTUNITY AS A BUSINESS ANALYST AND I DNT HAVE ANY KNOWLEDGE ON ORACLE APPS/GIVE ME ANY VALUBLE SUGGESTION?
