Interested to Buy Any Domain ? << Click Here >> for more details...
for a 11kv transmission line what capacity of CTs & PTs are
required?
- 4 Answers
- 11212 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivadathathri
11 KV CTs & PTs , Out door Pedestal mounting versions will do. Current ratio , STC Rating & Insulation level can be determined with connected load. Like breaker / Transformer Etc. Example : Load is 11KV 100KVA transformer is connected . Then use 11KV Cts CTR: 5/5 Amps , Class 0.5 for metering , Class : 5p10 for Protection . OCF - 150XI nominal . Oil cooled CTs for MUSS. If it is mounted inside panel / Control room then Use Resin cast type. SHIVADATHATHRI- 9632153842.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the id1 & id2 setting in differential protection relay of CSPC?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
bitumar
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
What is the name of transformers oil filteration equipment?
how slip power recovery system work
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
What descriptive information does the NEC require to be marked on all conductors?
what is the relationship between phase & neutral
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
