Answer Posted / k.prakashchandra
It is the difference between the synchronous speed ( Ns) and actual speed of the rotor or rotor speed (Nr). It can be expressed in per minute ( Ns - Nr ,both being rpm ),per second or percentage ( Ns - Nr)x 100 /Ns .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
Why efficiency in thermal power plant is low?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
Explain the advantages and disadvantages of thermal power plant?
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
working of diesel generator ?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses