Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of turbo charger in generators
- 1 Answers
- 3501 Views
- I also Faced
- E-Mail Answers
Answer Posted / aman kaushik
Its function is to provide more air to burn fuel which will give more efficiency & to throw exhaust outside.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
What are all present producing cost of Per KWH of various Fuel?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
What is the difference between the relay and the circuit breaker?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
5.WHICH TYPE WELDING PROCESSES USES NON CONSUMABLE ELECTRODE.........
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
what is difference between bus coupler and auto transfer switch
If not into production, how far did you follow the design and why did not you see it into production?
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
WHAT IS counter flux IN CT?
