how can change 12mmdia@150c/c bar spacing to 16mmdia
- 2 Answers
- 5292 Views
- Apex, I also Faced
- E-Mail Answers
Answer Posted / priyabrata bal
d1-12mm, d2-16mm, s1-150mm, s2-?
d1^2/s1 = d2^2/S2
S2 = D2^2 * S1 /D1^2
16^2 *150/12^2
=266.66MM
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
Define What is a projection line?
2. What are the advantages of your present job, things you like about it?
what is kribs is supporting?
What things you need to take care of before building a kitchen island?
Explain the Strength of brick?
I want to know how much the lapping length for the pilecap reinforcement.. we r using single pile cap which is 24mby54m and 2.5m depth.. total 91piles are supporting the pile cap.. how to do a steel reinforcement??
how much required strength of cement concrete bricks(size 230x115x75mm)
how is the reinforcement is distributed in triangular slab
what is the Asfalt test?in road constraction..?
how to calculate Rate of analysis for 100 m3 Any ratio of concrete ? including labour
How can we demolish concrete beams?
What is the use of extend command?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
what is the clear cover for shearwall?
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
