Interested to Buy Any Domain ? << Click Here >> for more details...
WHY WE USE CABLE JUNCTION AFTER BETWEEN TANSMISSION LINE
AND TRANSFORMER
- 1 Answers
- 3280 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / pritish
junction cable is placed in between the trans. and a sub station due to the following reasons.
when a high voltage surge fall on the transmission line it propagates to the either side of the tr. line. we know that the surge impedance of a transmission line is nearly 400 ohm and the surge impedance of a cable is 40 ohms. hence when a surge comes to the sub station from tr. line, the magnitude of surge voltage decreases to a great extent on the cable side due to voltage divider rule. hence the equipments in the SS can be protected.
for details contact :pritish.nath@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
In what condition the HT fuse breakes?
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
how many single tension hardware are required on a double circuit transmission tower?
What is the basic of DTH.
WTA used cb?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
why we used ZNO in Lightning arrester.
what happen ehen synchronisation is done at below rated speed
How we can defined theecopper cable size if we know the aluminium cable size?
What is reverse power relay?
