Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate flow of air bubbler type level transmiter
According hight and density
- 2 Answers
- 5779 Views
- Qatar Petroleums, RKS, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
Question: How to calculate flow of air bubbler type level transmiter? According hight and density?
I love this question because it deals with the understanding of how a bubbler works - flow is not the issue, pressure is.
The calculated value for a bubbler is NOT flow. The critical, calculated value for a bubbler is pressure, because the air/gas pressure in the bubbler tube is a direct representation of the head pressure of the liquid column; which in turn, can be interpreted as the level of the liquid column.
Measurements of head pressure are always done in units of water column (wc), inches of water column or mm of water column, because water column is universal everywhere in the world.
The column of liquid might not be water, it might be some chemical or solution whose specific gravity (density) is not the same as water. So to determine the level, the head pressure measurement of the air/gas pressure in the bubbler dip tube needs to be corrected by the specific gravity. Level = measurement (wc)/specific gravity
The flow rate of air/gas is typically just enough to create a constant stream of bubbles, proving that the air/gas column in the tube has sufficient pressure to overcome the liquid column head pressure. Flow rates regulated by a constant flow, differential relay range from 0.5-2.0 CFH (15 L/hr to 55 L/hr).
Carl Ellis
Measure First
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is sliding spool valves?
How oil line flow measured?eplain about instruments used and working principle?
Draw a group of instruments interlocked to a Pump & Motor?
where proximity sensor installed on tank in loading arm application
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
What is difference between ESD and PLC please Explain me clearly.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
Explain plc level and its type?
how many types of preheaters are in cement industry & what r they can any body explain?
how do calibrate the valves.. with clear manual
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
what does it mean an active front end in vfd plz explain it briefly
What is the difference between ff transmitter and non ff transmitter
Explain types of valves?
