what are upstream faults and downstream faults in power system
- 2 Answers
- 9145 Views
- Sreetech, I also Faced
- E-Mail Answers
Answer Posted / svasu30
please give me reply for this question as soon as possible
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is the formulae of Megger value for a A.C.Motor
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
Why a tesa lamp is glow between two phase?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
What is mathematical model of a control system?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
Is it possible to measure the voltage of a battery from a single terminal?
what is ratio of copper wire size and current ?
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
Why neutral is not used in three phases dol starter
why would amp draw on neutral wire be as much as amp draw on the hot leg.
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
What is inrush current?
