Interested to Buy Any Domain ? << Click Here >> for more details...
In a ball valve which require 24v dc supply to operate, whose solenoid valve doesn't have any + or - indication, how can we make wiring connectionto solenoid valve?
- 1 Answers
- 4367 Views
- Process Control Technologies, I also Faced
- E-Mail Answers
Answer Posted / narendra
u can connect diode & check it by providing power supply,as it will not damage the the solenoid even polarity is changed.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
typical loop drawing of a simple feedback control comprising of one transmitter and one control
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
why we are not using the turbine flow meter in the steam service?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
What is the difference between modbus,fieldbus & profibus
What do you know about gail?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Define cryogenic?
Explain signal isolator
