what is difference b/w earth and ground?
- 7 Answers
- 8909 Views
- TATA, TCS, I also Faced
- E-Mail Answers
Answer Posted / vitthal
grounding is done in electrical system like nutral grouting i.e for equpments protection & alternater body is earthed for human protection & doesen't says body grounding.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
What is corkscrew rule?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
How i can calculate current of cable according to ares?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
Explain the purpose of inductor in an electric circuit?
