Interested to Buy Any Domain ? << Click Here >> for more details...
qty of cement,sand and aggregate (1:3:6) required for RCC
Slab size 1000 x 500 x 100 mm
- 6 Answers
- 13781 Views
- APGenco, I also Faced
- E-Mail Answers
Answer Posted / arif sherani
Cement 0.068cube
Send .0173cubi
Aggregate .03465cube
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
how much cement and sand consuptin in 4 inch siporex walls 100 sq ft
Define What are the reasons for geotechnical site investigations in Uganda?
what is differences between ferrock and concrete ?
How to calculate the load of partion in flat slab if we use brick?
How can i do RCC rate analysis?
hii.plz send me hpcl placement papers for officers trainees for graduate engg plz my email id is ajm_knit@yahoo.com
Is it worthwhile to carry out tests on particle density of soil particles for geotechnical design?
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
What is binding spacing of the rebars at lapping zones.
Explain what is change order request?
What are the standard plastic limit/liquid limit/plasticityindex for differrent type of soils?
Differentiate first angle & third angle projection?
