1.In two wattmeter method if one wattmeter shows Negative
reading then wat is reason?
2.Wat is the reason for low voltage in houses?
3.Wat is meant by current and voltage? wat is difference
between the two?
- 10 Answers
- 62070 Views
- Engineering, I also Faced
- E-Mail Answers
Answer Posted / nitin banegaon
its sooo simlpe. when induction motor is on load then the no load current will have two components one is active/load component and other magnetizing component. Magnetizing component is for creating magnetic field to spin the motor which is independent of load current and it lags behind the voltage by 90. Initially on load, current is so small which is normally is in phase with applied voltage. So on no load circuit is inductive. So power factor is small nearly 0.2 to 0.4.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
Why is better to have a minimum ceiling voltage of 250% than 160%?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
can u please mail me the syllabus for GET exam for damodar valley corporation?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
Why cables and busbar both needed in LT Panels?
How to measure size of cable on a given load
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
How to distinguish whether MCB is DC or AC looking at it physically
what is mean by transition resistance of transformer?
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
why zero sequence impedance measurement is not applicable for single phase GT
What is a compensator?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
state the working of discharge lamp?
