Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 30206 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / vikas tiwari
CT means Current Transformer, It is used to measure the
higher value current flowing through the circuit.
CT should be connected in such a way that the current
should enter from the P1(primary) & leave from P2, Also on
secodary side S1 & S2 should be connected with correct
sequency other wise the meter will not sense the current,
While CT is not in use, we should short the S1 & S2
(Secondary) of the CT to avoid saturation of the CT.
If the seconday of loaded CT will be kept open it will get
saturated & burst
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
Define availability (operational)?
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
what is a types of short circuit and what is a types of distance protection tests
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
how to find impedance , mutual indatnce in transmission lines
area control error
What aturn on methods of scr?
How to Design green buildings services? What is the advantage to design green building?
in india per day how much power is generated including all power station
I had applied for JE in PSEB, Can you pls send me the Question bank for related to my field
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
