Interested to Buy Any Domain ? << Click Here >> for more details...
what is the usage of QDV & VOLUME BOOSTER.
- 2 Answers
- 5142 Views
- ADMA OPCO, I also Faced
- E-Mail Answers
Answer Posted / dhananjayk
Volume booster is using where we need quick opning of valve or where big dom which need more air volume for operating valve in time
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
Describe how to use megger to measure the earth resistance and insulation resistance
Explain the difference between mmwc and mmwg?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
How to calibrate level transmitter with use of HART?
what is diffrance between FF & SMART, explain with difination
What are the uses of orifice plates?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is difference between radial vibration and axial vibration explain in detail .
what is piezoelectric transducer?give an example in power plant n state its principle?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
