Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / farhan
Dcs under stand just 1 to 5 volts therefore 1---5volts enters in it.there is a currernt to volt converter available in dcs.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how works encoder in plc
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how to design orifice plate?what is the equation?
What is the reason PT speed not incresed in gas turbine?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
How to check vortex flow meter is in good condition while we do not having calibration setup?
How to Calibrate Flow Switch in field
Draw a group of instruments interlocked to a Pump & Motor?
I need to know steps to Calibration Valve Guard......
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
TECHNICAL/ARTITUDE
Any body have know try work calculation ???
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
