Interested to Buy Any Domain ? << Click Here >> for more details...
compare the thermocouple and pyrometer,which one is the best?why?
- 4 Answers
- 18012 Views
- Ramco, I also Faced
- E-Mail Answers
Answer Posted / prithiviraj
thermocouple is contact type measuring device which can be used up to 1100 deg/cel. whilepyrometer is a non contact measuring device which can be used up to 1100 deg/cel.both are best according to the application
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why we are not using the turbine flow meter in the steam service?
why is not useing in boiler skin thermocople
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Operational amplifiers
What is Positive Calibration and Negative Calibration?
what is the responsibility of an instrument commissioning supervisor
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
i am having information technology branh ....... can i prepare for psu exam
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Calibration of controller (pneumatic)
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Explain bernoulli’s theorem. State its application.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
