Interested to Buy Any Domain ? << Click Here >> for more details...
Two CTs 1600/1 and 35/1 are in series. while checking the
ratio test of a CT(1600/1),same 1600A will also pass
through the CT having ratio 35/1.
Will it be harmfull to the ct(35/1),if yes , what will
happen.CT secondary is shorted
- 3 Answers
- 7072 Views
- I also Faced
- E-Mail Answers
Answer Posted / nur.asidik
refer to IEC, CT can withstand for 1s if current at primary is 1000xIn, mean 35kA is maximal. saturated or not is depend on Rct and burden, need to be calculated
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the copper in HT motors if KW, RPM & Voltage is given
why we r not earthed Control cable of C.T. terminals
does a DG set has low fault level as compared to that of a transformer.If yes then why.
how to ctrl motor by use of ac or dc drive.plz explain evdintly
what is the working principle of energy saver control panel. please give the complete calculation & theory.
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
which connection is safer series or parallel?usually which connection we prefer at home?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
How to calculate ant test the burden of Current transformer
how to calculate short circuit current for the busbar
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
What is the working mechanism of OLTC in Power Transformers????
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
