What is the clear distance between a MV panel(rear side) and wall.
Answer Posted / nur.asidik
refer to IEC about AFLR, it require 900mm minimal for rear side clearance and 1300mm for front panel clearance, and 600mm for ceiling
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
What is the meaning of dedicated earthing?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
what is the difference between the characteristics of two different phase bushing of any transformer
Why 1/3 is used in symmetrical components?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
how harmonics generated in induction furnance? how minimise it?
what is the maintaining Cf in UPS.
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
What is your acheivements
How to calculate the sag on transmission Lines.
What will happen if the voltage in my house drops from 220V to any lower voltage?
what is differentila pilot supervision in the incomer control panel in the power station?