Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rich sawe
CTPT - The Current Transformer and Potential Transformer,
these are instrument transformers used mainly for high voltage instrumentation purposes at the substation
1.Measurement purposes;these transformers provides low level signals to the metering equipments to measure line voltage level and line currents at the substation.
2.Protection purpose;these transformers provides signals to the upon occurrence of fault , over-current and under-current faults are firstly sensed by the current transformers then signals the O-C/U-C RELAY to trip the Circuit breaker ,Over-voltage and under-voltage faults is firstly sensed by Potential Transformer then signals the O-V/U-V RELAY to trip the Circuit breaker.
3. The occurrence of unbalanced fault condition in three phases at the substation is detected by the current transformers and potential transformers and the signal is fed to the respective relay to operate the circuit breaker.
4.on the POWER GRID the performance and operating status of the HIGH VOLTAGE SUBSTATION are monitored and controlled through feedback from CTPT
...DIT TANZANIA...
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
what do you mean by plant earthing system.
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
what is frequency response?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
description with working of all parts of a Diesel generator???????
What is formula calculation size cable wire ?
how can i improve the power factor in domestic (230v)
can someone explain that how the speed of the protection system affects the fault level calculation?
What is the drawback of class b amplifier?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
What are approaches to tackle sedimentation problem of reservoir?
the problem faced on star or delta winding connection??
how we calculate the withstansing current capacity of wires&cables?
