Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prasad appadi
Calibration is nothing but compare the span and zero we will check it the accuracy of instruments
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
how to work static pressure sensore how to work dpt
Explain plc level and its type?
plz send me general of ongc
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
how to calibrate and troubleshooting of leveltroll?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
what is exact time to study dcs and plc cources
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What is the difference between working pressure and calibration pressure of a control valve
How d.p. Transmitter can be applied to close tank?
how to calculate range of level transmitter?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
what are the values of fuel flow rate in various places in boiler.
