Answer Posted / innocent francis
FOR M30, the fundamental ratio is 1:1:2,above that the mix design will give the guide.
Is This Answer Correct ? | 6 Yes | 9 No |
Post New Answer View All Answers
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
how do you calculate the quantity of steel,cement for plinth beam. (example size 41'*0.58'*1.08')
What is the coeffiencent Friction Angle between Steel and Ashphalt?
How to find beam R/F cutting length
whats is difference between anchorage length and development length
what would be the design load of R.C.C Cooling tower per cell.?
step by step procedure to find out the percentage of steel in coloum,beam,slab,footing in detailed
Minimum concrete cover in slabs, columns, beams, foundation and other st?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
how much to get of BRC lapping in full yield and half yield ?
Define What materials were used to build the Golden Gate Bridge?
what is Brick crushing strength(PSI)?
How do you measure water flowing through 300mm diameter pipes?
Reinforced concrete: suppose you are doing rough estimate for purchase of rebar for reinforced concrete slab for single stores residential building. You know total concrete volume will be 100 m3. How many tons rebar 6, 10 and 12mm will you require for the project?
cause of cylinder test failure