Interested to Buy Any Domain ? << Click Here >> for more details...
what is pt100 RTD, and does 100 stands for
- 8 Answers
- 42754 Views
- Tata Power, I also Faced
- E-Mail Answers
Answer Posted / ayaz
upper all answer is minor wrong
RTD=RESISTANCE TEMPERATURE DETECTOR
PT= PLATINUM this is material we use in RTD
1OO= 100 ohm
AND PT100= PLATINUM IS Odeg C at 100 ohm
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
What is the use of temprature compensation?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is the purpose of the analyzer in petrochemical plant?
what is interlock system and why we use of this?
please tel me the calibration of pneumatic controler.
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Identification of ss fittings, pilot valves, relief valve.
How can a d.p. Transmitter be calibrated?
What is the principle of capacitance type level transmitter?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
What is the diffrence between ff tx and non ff tx
what are the steps I have to deal with?
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
What is the difference between modbus,fieldbus & profibus
How to calibrate Magnetic flow Transmitter in Field
