Interested to Buy Any Domain ? << Click Here >> for more details...
how to rectify the problem ,if we erected the DPT instrument
wrongly of hp on lp side and lp on hp side?
- 5 Answers
- 9506 Views
- I also Faced
- E-Mail Answers
Answer Posted / ayaz
no problem when DPT transmitter wrong leg hp and lp mount the transmitter will show the negative indication
so you not remove the transmitter but only re-range the transmitter value with hart communicator on lp side put negative and hp side positive range
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Specify for Cables - Flame Retardant and Fire Resistant?
what is thermo coupler and how it works
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
What is the use of temperature compensation?
line up procedure for dp type flow transmitter?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
why we are not using the turbine flow meter in the steam service?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
How the sizing of the analog signal cable is calculate?
