Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference Marshaling box and RTCC (Relay tap changer circuit) Panel of transformer ?
- 1 Answers
- 6114 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhara. s
Marshelling box is generally erected at switch yard near the trafo & RTCC is erected at control room. MB is to marshell control cables from control & relay panel also from RTCC to OLTC & other supervision & cooling control system connected to transformer tank. RTCC panel is to operate tap & to supervise transformer heating & cooling conditions.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is mason's gain formula?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is difference between 2 pole structure and 4 pole structure in transformer yard
what is the carona effects meaning in HT line transmmission system
What is inverse definite minimum time lag relay? Where is it use?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
why we can stote dc? why we cant store ac?
what is difference between window type and wound type transformers?where we will use window type and wound type transformers?
What is slope...? Explain slope 1 and slope 2...?
Write down the design procedure of commutaj.
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
what is the acceptable limit value for Desolve Gas Analysis/
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
