Answer Posted / ashish namdev
Instrumentation is automation
then we can run any equipment safe mode, remote controlling
all is automatically
Ashish Namdev (sr. engg)
Jaypee power plant, Bina (MP)
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How many interlocks at turbine side?
What is loop1 and loop2 in MTS LT?
How to Calibrate Vibration Probe (Axial, Redial) in field
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
What is three element drum level control system why its better than single element?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
How is flow measured in square root?
what is the vital subject for scoring bhel exam&what is the question pattern
what is cems analyzer explain with principle and drawing ?
how to commission furnace ( water heater)
what is the reset offset and control system in instrumentation
kindly sent some demo question and answer
protection relay watchdog contact operation?
Why are the uses 24vdc in industries
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?