Interested to Buy Any Domain ? << Click Here >> for more details...
Why some transmitter shows flow in MMWC and some in TPH?
- 2 Answers
- 20250 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish namdev
MMWC is a unit of differential pressure but TPH is a unit of flow rate.MMWC can be convert in flow rate
Q = ^P
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Specify for Cables - Flame Retardant and Fire Resistant?
what is dc moter.
applications of plc in printing and packaging?
types of cable..? Use of every types of cable..?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
In Safe Guarding test what means by "Failed to Danger" ?
what is IEC code in cables & how to selecting cables?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
what is the calibration procedure for magnetic flow meter @ onsite
how to commission furnace ( water heater)
what is wave length were using ?
Explain operation of Haskel pump.
What is the difference between ff transmitter and non ff transmitter
How is automatic reference junction compensation carried out in temperature recorders?
