i am having a 3 phase 12.5HP motor,that is connected in
Star/delta.Without any Trip that motor stopped suddenly
why?
Answer Posted / ashok
Control circuit wire is loose conection..
Check the control circuit wire,in adanblock and
Coil side...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how does a shunt reactor maintains the bus voltage???
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
can the measured percentage error during calibration of single phase energy meter be negative?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
diff b/w elcb and rccb
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
how we findout a ignater is faulty or not?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
What is float cum boost charging system?
What is DTR erection?
What is turn ratio of a transformer?
power transmission pole used one support , that only for support or earthing
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?