Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / om prakash khairwar
It is the branch of engineering which deals with the
measurement, monitoring, display etc.,
different ans is actually instrument is the eye and brain of the plant.
Suppose cut in our legs bt our eyes and brain only see and think and need hands for etc work.... So ans is clear instrument only sense and operator think what is the problem ... Mechnical... Instrument... Electrical and process problems.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how many types of spped sensors n vibration sensors?their basic principle n connection?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
What is force balance principle? State some of its’ advantages.
What is the reason PT speed not incresed in gas turbine?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Can anyone send most commonly asked interview question in Oil & Gas industry
What is the procedure of calibration of Load cell?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
What are different type of instrument cable
any questions on motor and energy conversions machines?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
TEMPERATURE VARIATION FOR FREQUENTLY.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
