Interested to Buy Any Domain ? << Click Here >> for more details...
What are the different protection systems takes place on
control panel board?
- 7 Answers
- 38757 Views
- BSNL, I also Faced
- E-Mail Answers
Answer Posted / vengatesh
1.Circuit Breaker
2.Protection relays
3.Fuse(over current protection)
4.Earthing(For drawn the Fault current which is higher than normal voltage)
5.Control panel body earthing(To prevent the body shorts)
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
what is fault level of power system ?
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
What is gain margin?
The principle of switching circuits for different types of batteries in application of storage systems
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
why we testing the core balance of the transformer before comissioning?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Explain about Leakage Test.
HOW TO WORK A VFD?SAY SIMPLE METHOD
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
How line capacitance & line inductance varies with increase in height tower.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
why we use single core 630mm2 cable for transformer secondary side
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
