Interested to Buy Any Domain ? << Click Here >> for more details...
hi i'm an Instrumentation student,i have one doubt that we
can call-
> computer science as CS
> Information science as IS
> Electronics & communication as E & C
In the same way what is short term for Instrumentation....?
- 11 Answers
- 13744 Views
- I also Faced
- E-Mail Answers
Answer Posted / mansour
INSTRUMENTATION IS MEASURE AND CONTROL THE PARAMETERS LIKE
TEMP. PRESSURE LEVEL AND FLOW.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What is the PLC configuration in Cement industry?
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
What is shielding effect?
How ejector(or)evactor air pump is working in thermal power plant?
What is zero elevation and zero suppression?
Why ac supply load cell is used? Can we use the dc supply load cell?
What is the use of control cable?
flow transmitter formula?
How to work togather like sov,limit switch,proxy switch and booster in xv
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
How to Calibrate Ultrasonic flow Transmitter in Field
