Interested to Buy Any Domain ? << Click Here >> for more details...
What is the selection criteria of Natural Draught Cooling
Tower and Induced Draught Cooling Tower . Where we prefer
NDCT and where IDCT.
- 4 Answers
- 16033 Views
- IRCTC, Lanco, I also Faced
- E-Mail Answers
Answer Posted / kapil
The selection criteria also depends upon the cost economics. The capital cost of NDCT is more than IDCT.Hence in calculating the tariff the loading of NDCT capital cost w.r.t coal transportation factor is also considered. Normally sea water application favor NDCTs.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what is tranformer and transducer
How do you calculate cooling energy?
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
What are the thermal conductivity properties of brass?
What do you measure in the banana and mountain diagram?
How do concrete pumps work?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is the purpose of air blow?
What is the different types of surge tanks ?
Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?
WHAT MADE YOU BECOME AN ELECTO-MECHANICAL ENGINEER?WHAT IS YOUR JOB DESCRIPTION?WHERE DO YOU WORK?WHAT ARE YOUR JOB RESPONSIBILITIES?WHAT IS YOUR WORK ENVIRONMENT LIKE?WHAT IS YOUR EDUCATIONAL BACKGROUND?WHAT COURSES DID YOU NEED OR ARE VALUABLE FOR YOUR POSITION?WHAT ARE THE ADVANTAGES OF YOUR JOB?WHAT ARE THE DISADVANTAGES?WHAT MADE YOU GO INT THE FIELD?HOW MUCH SCHOOLING DID YOU NEED?WHAT DID YOU NEED TO STUDY?
How many years did it take for you to complete school?
how to solved the crictical problems in d. g. set
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
What is hess law?
