Interested to Buy Any Domain ? << Click Here >> for more details...
What is AVR? Explain the function AVR?
- 11 Answers
- 72726 Views
- HSL, NHPC, I also Faced
- E-Mail Answers
Answer Posted / rama kishore karri
AVR is an automatic voltage regulator. The function of AVR is to keep the terminal voltage constant as load variation on power lines. Moreover, the output voltage variation is more likely to be severe because changes in the load power factor. For example an alternator AVR changes the alternator field current to compensate for either increase or decrease load voltage. A controller is used to increase or decrease the field current through field circuit. As the AC voltage falls field controller circuit causes to increase the flux and thus induces increased voltage and vice verse
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
What is the efficiency during maximum power transfer?
How will polarity test of Dy5 Transformer ?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
What is the important precuations need tocarried out while working with Electrolite in Battery PM?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
how we explain parallel paths armature winding?
what is the prinsiple of dc motor and construction and working ,application of dc motor.
What is vacuum circuit breaker.define with cause and where be use it device?
how to measure earth resistance of a substation
What are the specifications for conducting earth leakage test as per IEC standard?
What is cathode ray oscilloscope (cro)?
How to calculate cable size by using load.?? Any formula...
