Interested to Buy Any Domain ? << Click Here >> for more details...
what is the procedure to isolate flow a transmitter and
flushing it?
- 8 Answers
- 42503 Views
- Petrofac, I also Faced
- E-Mail Answers
Answer Posted / aswin
First job is to zero check of Tx.
If it will show zero meanns, Tx is ok on its 0 value.
Now u hav to close both isolatoin valve of Tx manifold.
Now open the drain plug of Transmitter.Tx show 0 value.
Next to open drain valave of both H.P AND L.P.(LIR).
The total water will drain out from impulse pipe.
If still u r not getting any flow of water in drain line it means ur lines are severely choked.
After jamming cleared again u hav to charged Tx by some step by step procedure.If condensing pot is there then u v to carefully charge the line.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Calibration procedure for electro magnetic flow meter
How to calibrate an pressure gauge with yantrika test bench?
How will you test a transistor with a multimeter?
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
whatis range of marcury filled tempereture gague
Explain operation of Haskel pump.
what is the protection system in solar turbine compressor
how to relay switch sense the fault?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
what is the different between deflection type measurement and null type measurement in RTD?
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is the use of double seated valve?
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
