What is the function of Antipumping Relay and Lockout Relay?
- 1 Answers
- 3934 Views
- I also Faced
- E-Mail Answers
Answer Posted / avdhesh
Antipumping Relay : It is generaly used in series of
closing coil of breaker. The function is to cut off the
supply of closing coil immediately after closing of
breaker. This is required as coil is not designed for
continous rating.
Lockout relay : This is also used in closing ckt of
breaker. This is basicaly latched relay which inihibit the
closing of breaker for defined time if relay is operated.
Lockout relay can be self reset or manual reset (choice)
after definite time.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is package substation.how many types they have
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
What is power relay?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
What is Harmonics how it is produced and what is the method to control the same
state working of halogen lamp?
If a high resistance fault occurs,then what are the changes will happen in the system?
