Interested to Buy Any Domain ? << Click Here >> for more details...
What is the deffrence between Siemens S7-300 & S7-400 PLC?
- 4 Answers
- 33038 Views
- ADC, I also Faced
- E-Mail Answers
Answer Posted / guna
S7-300 plc is a mid end plc rated by the Siemens, This
rating is depends on so many constraints but main
consideration on Number of I/O's & Instruction set, No.of
baud-rates, Cost per module. it works on the Simatic
manager driver software. it is available in compact and
modular types. this needs separate flash memory cards
(Removable)in cpu memory to store the data.
S7-400 is a high end plc means its capacity is larger when
compared to s7-300 in all the ways like technically and
physically. it can also work on the simatic manager. S7-400
is also called as DCS (distributed control systems) which
works on the driver software of PCS-7. its memory capacity
is above 64mb(very high).
the hardware configuration of both the plc types differs
a lot.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what about GD square and its important for motor design?
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
what is the relative size of single and three phase?
can i able to get bhel previous exam question paper?
How to set a Zone 1 distance relay for distribution feeder?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
Mention the disadvantages of low power factor?
What is the operating principle of turbo-generator.
what is the use of the puls transformer in UPS & how it works???????????
what is the terminal voltage of dc series generator running at rated speed at no load?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
operation of protection relay watchdog contact?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Explain how you intend to work under pressure to meet up with deadline target?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
