Interested to Buy Any Domain ? << Click Here >> for more details...
In electronic board one fuse(rating 230v,100ma)showing 2.5
ohms with multimeter,then the fuse is healthy or not.
- 4 Answers
- 7618 Views
- I also Faced
- E-Mail Answers
Answer Posted / samir
no it is unhealthy. Because it gives voltage drop between
the two ends.
In the circuit board this resistance of 2.5 Ohm is due to
the circuit other component. Actually fuse is generally
check by removing that fuse from the circuit board.
Ideally the fuse resistance is nearest to 0.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
what is span value and zero ? and how set ?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
define feed forward control loop with example and drawing?
Explain the use of hair spring in the pressure gauge.
Why grounding is necessary? Give example with diagram.
How to Calibrate Level Switch in field
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
Why plc require in analog input 4-20amp & 0-10 volt?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Explain about the leakage class of the control valves
Linear amplifier.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
How servomotor controls throttle valve of TURBINE?
what is zero and span ?
